Advent 300 User Manual

Operating controls
Power Turns the receiver
On and Off. It is nor
mal for the Model
300
to make
a thumping noise
when it is turned On or Off.
Power indicator Lights
when receiver is On.
The indicator
light will glow for
a
few
seconds
after the power is switched
Off.
Tuning
knob Rotate the Tuning knob until the
desired FM station “pops” into listening range.
Rock the dial
back and forth until the twin Tun
ing indicator lights
glow with equal intensity,
signaling optimum
tuning for minimum noise
and
distortion.
Tuning indicator
lights Indicate precise center
of a station when
tuned for equal brightness.
Stereo indicator Lights when tuner receives a
station broadcasting a stereo signal.
Selector Selects program source—Aux, Tuner,
or Phono
— for listening or recording.
(With tape
deck connected to Tape in jacks, select tape
playback
by
switching Tape monitor In.)
Tape monitor Switch to In for tape playback, or
to monitor
a
tape while it is being recorded with
a three head deck. Note: Tape monitor
switch
must be in Out position for listening to sources
other than tape. When no tape deck is oper
ating,
switching to In will result in no sound.
Volume Adjusts the
volume
of both channels
simultaneously.
U
,G_000 00
TAPE MONITOR LOUDNESS MONO STEREO
On
O
Ofl
“‘
ON
MUTING SPEAKERS
PHONES
AUG
TUNED PUONO
VOLUME BALANCE BASS TREBLE
+
98
100 102
104
96
94
\\
/
106
92\
I /
90
108
88
ADVE\T
MODEL 300
POWER

Advent 300 Specifications

General

Brand	Advent
Model	300
Category	Stereo Receiver
Language	English