Recharging the Battery Pack
A Remove battery pack from speaker. Make certain
the batteries in the pack (I) are rechargeable.
B Insert the power cord from the 15 V AC adapter
(Q) into the battery pack input jack.
C Plug the Speaker AC Adapter (Q) in any standard
wall outlet.
D Allow unit to charge for at least 8 hours for a full
charge.
E Replace battery pack (I) into speaker.
NOTE If you are using rechargeable batteries NiMH or
NiCad, the batteries will not recharge when the
speaker is powered with the AC adapter. Please DO
NOT attempt to recharge alkaline or other non-
rechargeable batteries – this could cause the
batteries to leak which would damage the speaker.
ADVENT ADVW801 900 MHz Wireless Outdoor/Indoor Speaker System
6
Power the Speaker
Select from the following options to power
the ADVW801 speaker:
POWER OPTION 1 “D” CELL BATTERIES
A Turn the speaker Power ON-OFF/Volume Control
Knob (A) to the “OFF” position (all the way counter-
clockwise – it will “click” off).
B Remove the Battery Compartment Cover (H).
C Insert eight (8) “D” batteries (sold seperately) into
the speaker following the polarity (“+” and “–”)
as diagrammed in the battery compartment.
D Replace the Battery Compartment Cover.
5
ADVENT ADVW801 900 MHz Wireless Outdoor/Indoor Speaker System
Battery
Compartment
Cover (H)
8 “D” Cell
Batteries
(sold sperately)
Battery Compartment
Screws (G)
Battery
Compartment (I)
Battery
Compartment
(I)
Input Jack
To Next Page
Loading...
Need help?
General
