1
www.observint.com
ALI-NS1024VR_CQ
10/9/15
Power Connector
Alarm in/out and audio out terminals
Terminals identity label
Ethernet connector
Camera drop cable connectors
What’s in the box
• Camera assembly
• Drill template
• Lens Adjuster (for camera module)
• Torx™ L- wrench
• Alibi Discover tool and documentation CD
• Mounting hardware (screws and wall inserts (3 each))
• Adapter plate
• This manual
Torx
L-wrench
Mounting hardware
Lens adjuster
Alibi Discover tool and
Documentation CD
Weatherproof tting
for Ethernet cable
Adapter plate
Tools you need
To install the camera, you will need:
• 12 Vdc power source. See Specications for voltage and wattage requirements.
• Tools and additional fasteners (may be required) for mounting the camera
• Ethernet and power extension cables
Step 1. Insert MicroSD card into the camera
A MicroSD card installed in the provides local storage for video recordings, capture les, and log data. The
MicroSD card can hold as much as 128 GB of data. NOTE: If the camera is not managed by an NVR or other
video management system (VMS), and doesn’t have a MicroSD card, video recordings, capture les, and
log data are not saved.
1. Remove the camera cover. Use the L-wrench to unscrew the four captive screws that secure the cover
to the base assembly, and then separate it from the base assembly. At this time, do not remove the
plastic lm that protects the clear plastic dome.
ALI-NS1024VR 4.0 Megapixel IR Mini Dome
IP Camera Quick Installation Guide
The ALIBI ALI-NS1024VR dome camera includes 4.0 megapixel video performance in a small form factor
network camera. The camera can be mounted directly to a ceiling, or onto a 3-gang box using the adapter
plate provided.
Features
• 4.0 Megapixel video
• Up to 30 ft (10 m) IR
• 120dB WDR/3D DNR/BLC
• Support on-board storage, up to 128GB
• Built-in microphone
• 12 Vdc or Power over Ethernet (PoE)
• Internal 3-axis adjustment
• IP66 weather rated, IK08 impact resistant
Cover
Cover
screws (4)
Microphone
port
Microphone
Base assembly
Reset button*
IR array
Lens
Camera
module
MicroSD card slot
Pan adjust.
lock screw
Hole for
mounting
screw
(1 of 2)
For factory
use only
Base assembly internal components
* To Reset the camera to its factory default state, hold down the button for 10 seconds while the camera is
powering on or rebooting.
To Next Page
Need help?
General
