FX1 EFFECTS
These are the echo and modulation effects usually
applied for special effect.
Each channel has a wet/dry control to determine how
much signal is routed direct (dry) to the LR mix, or
via the effects processor (wet) to the LR mix. When
set fully wet it is known as an ‘insertion effect’ as all
the signal is processed. When mixed with dry it
behaves as a ‘system effect’ as the effect is added to
the dry signal. Make sure the FX1 fader is set to ‘0’
when using insertion effects.
Set the echo delay time using the DLY parameter, the
amount of feedback (repeat) using REG, how fast the
high frequency content decays using DMP, and the
global wet/dry mix using DRY. Set the modulation
speed and depth of effect using SPD and DEP.
FX1 parameter 1 parameter 2 parameter 3 parameter 4
1-8
M ECHO 1-8
Mono echo - Combines left and right signals to feed the echo
DLY delay
10 to 740mS
DMP damping
1 to 25
REG regeneration
0 to 99 %
DRY
1 to 25
9-14
15-18
S ECHO 1-6
BOUNCE 1-4
Stereo echo - Retains the stereo image of the echo signal
2-tap echo - Alternates between left and right channels. Ping pong effect
DLY delay
10 to 370mS
DMP damping
1 to 25
REG regeneration
0 to 99 %
DRY
1 to 25
18-20
CHORUS 1-3
Stereo chorus effect to thicken the sound
DEP depth
1 to 50
SPD speed
1 to 25
21-23
DOUBLER 1-3
Doubling effect to thicken the sound
DEP depth
1 to 50
DLY delay
1 to 180
24-25
26-27
28-30
MFLANGE 1,2
SFLANGE 1,2
PHUNNEL 1-3
Mono flanging effect
Stereo flanging effect
Metallic resonant phasing effect
DEP depth
1 to 50
SPD speed
1 to 25
REG regeneration
0 to 99 %
31-32
33-34
35-36
37-39
VIBRATO 1,2
St VIBE 1,2
TREMOLO 1,2
AUTOPAN 1-3
Mono vibrato (pitch) modulation
Stereo vibrato (pitch) modulation
Amplitude (volume) modulation
Amplitude modulation alternating between left and right channels
DEP depth
1 to 50
SPD speed
1 to 25
40
FOOT VOL FX1 foot pedal volume control
7 - 4 icon SERIES
To Next Page
Loading...
Need help?
General
