9
MIC AND FILTER CONTROLS
Filter Resonance control
Changes the “Q” or sharpness
of the VCF.
Mild will give a smooth filter
sound, Wild will make the
filter sound more pronounced
(sharper “Q”)
Filter type select
HPF - allows signals above the
cut-off frequency to pass.
LPF - allows signals below the
cut-off frequency to pass
FX loop on switch
Press this switch to activate
the external effect loop. Leave
switched off if an external
effects unit is not connected
Filter Frequency
Sets the cut off frequency of
the VCF filter
Microphone EQ
2 band EQ for adjusting the
tonal balance of the DJ mic
Microphone input
Professional XLR balanced mic
input. Use a low impedance
dynamic hypercardioid Mic for
best results.
Microphone Level
Adjusts the signal level of the
mic input. If you are not using
the mic, turn to minimum to
prevent noise pick up.
To Next Page
Loading...
Need help?
General
