STEREO INPUT CHANNEL 2
ST-2 Input
The USB audio input is connected through the
break contacts of the standard 1/4” (6.25mm) jack
sockets. Plugging into the jacks will override the
USB input, so if you want to use the ST-2 channel
for the USB input signal, make sure nothing is
plugged into the jack sockets.
The rest of the features of the ST-2 channel
are as described for ST-1
Important Note:
If the ST-2 channel is not being used for USB play-
back or stereo input it is best to keep the level
controls turned down so that unwanted noise from
the inactive USB device is not passed to the mix.
Record OUT
Standard RCA phono sockets for the stereo line
level Record outputs sourced from the USB out
selector switches. Useful for connecting to stereo
recording devices, stereo mix feeds, or where se-
lective channels are required to feed other equip-
ment.
Playback Input
Standard 1/4” (6.25mm) jack sockets for unbalanced
line level inputs. Can be used for additional stereo
sources such as CD players for background music,
or playing back a final mix from a recording device.
The USB audio input is connected through the
break contacts of these inputs, plugging into the
jack sockets overrides the USB input.
USB OUT Source selector switches
Select the signal source for the USB audio output
and the Record output. With both switches up the
main Mix is selected. The Record Bus switch will
override the Aux-FX switch if both are pressed.
!
To Next Page
Loading...
Need help?
General
