Allen & Heath 15 ZED-14 User Guide
MONO INPUT CHANNELS 1 TO 6
9
10
11
11
12
13
9
Auxes 1 & 2
Each of these controls sends a signal to an auxiliary bus. The
signal is sourced pre-fade which means that the level is inde-
pendent of, and unaffected by the fader. Auxes 1 & 2 are pri-
marily used for foldback monitoring purposes, as the fader does
not affect the level. They can also be used as feeds for re-
cording and are available sources to the USB interface for this
purpose.
These sends are affected by the Mute switch, so muting the
channel will also mute the Aux sends.
The control varies the signal level to the bus from off (fully at-
tenuated) to +6dB, with unity gain at the arrow.
10
Auxes 3 & 4
These are post-fade sends, which means that the signals are af-
fected by the channel fader. Primarily used for effects sends, the
aux signal will reduce if the fader is pulled down so keeping the
correct proportion of the effect.
Muting the channel will also mute the Aux sends, and the send
controls have 6dB gain fully clockwise.
There are no master level controls for Aux 3 & 4 outputs.
12
PAN
The pan control adjusts how the signal from the mono input
channel is shared between the left and right buses and subse-
quently the main stereo outputs. Set to the mid position, equal
amounts of signal are fed to left and right, with pan set to L,
none is sent to the Right bus.
13
PFL Switch & PK! LED
The PFL (Pre-Fade Listen) switch sends the channel signal to
the PFL bus and subsequently to the headphones and the main
L R meters. Used for checking the audio signal before raising
the fader or un-muting the channel.
The PK! LED illuminates dimly to indicate the PFL switch is
pressed, and brightly to indicate the channel signal is within 5dB
of clipping.
14
Mute Switch
This mutes or cuts the signal to the left & right buses and the
Aux buses. A rectangular LED illuminates to show the Mute
switch is pressed.
OO
30
5
10
20
5
0
10
OO
+6
AUX1
PRE
OO
+6
AUX2
PRE
OO
+6
AUX3
OO
+6
AUX4
POST
L R
PAN
=
PK !
PFL
MUTE
1
POST
14
Fader
The 100mm fader affects the level of the channel signal to the
left & right buses and Auxes 3 & 4. There is 10dB of gain at the
top and the unity gain position is marked by “0”.
To Next Page
Loading...
Need help?
General
