Allen & Heath 16 ZED-14 User Guide
STEREO INPUT CHANNEL 7-8
2
8
4
Stereo Return ON switch
This switches the signal on when pressed in. Leaving the
switch in the up position is recommended when the ste-
reo return input is not in use to minimise unwanted
noise being passed through.
1
Stereo Return Phono sockets
This is an additional stereo input to the main stereo
channel input (below). The gain is varied by the ST RTN
control and this input can be sent to either the stereo
channel or straight to the L R main bus, depending on
the setting of the under-panel switch. These inputs are
unbalanced.
OO
10
-30
-20
-5
0
5
-10
ST
RTN
To LR
To 7-8
ON
-30
-20
-5
5
0
OO
-10
10
IN
-15 +15
12kHz
HF
-15 +15
80Hz
LF
ST1
ST RTN
L
R
ST1 IN
L/M
R
1
5
3
6
2
Stereo Return Level control
Adjusts the level of the stereo return input from off
(fully attenuated) to maximum where it has 10dB of gain.
3
4
6
5
Stereo Routing selector switch
This switch selects whether the Stereo Return signal is
sent to the L R bus directly, or the stereo channel 1.
When it is pressed in, the Stereo Return signal sums to-
gether with the main stereo input.
Stereo 1 input jack sockets
Standard 1/4” jack sockets for line level stereo signals.
Can be used with a mono input where the L/M input will
also connect to the R input if nothing is plugged in to R.
The Stereo 1 inputs accept unbalanced or balanced sig-
nals.
Stereo 1 Level control
Adjusts the level of the ST1 input. The range is from off
to +10dB.
7
Stereo Channel EQ
The Stereo Channel EQ is 2 band with centre frequen-
cies of 12kHz for the HF and 80Hz for the LF.
7
1 0 .0 0 H z 10 0 .0 0 1 0 00 .0 0 1 0 00 0 .0 0 3 0 0 0 0 .0 0
-2 0. 0 0
-1 5. 0 0
-1 0. 0 0
-5 .0 0
0 .0 0
5 .0 0
1 0 . 0 0
1 5 . 0 0
2 0 . 0 0
d B r
To Next Page
Loading...
Need help?
General
