Allen & Heath 17 ZED-14 User Guide
STEREO CHANNEL 7-8
8
9
10
11
12
8
STEREO Aux 1 & 2 switch
This is an under-panel selector switch that configures Auxes 1
& 2 to be either mono sends or a stereo send pair.
UP: A mono sum of the left & right stereo channel signal is
sent to Aux buses 1 & 2 by the control knobs.
DOWN: The left stereo channel signal is sent to Aux 1 and
the right is sent to Aux 2 by the control knobs.
Note: This can be useful when setting up a seperate stereo
output from the main L R output using Auxes 1 & 2, possibly
for recording. This can be selected to feed the USB output to
create an independent stereo feed for recording using a com-
puter.
9
10
11
Balance control
The Balance control varies the relative levels between the left
and right channels.
12
Mute Switch
Mutes the signals to the main L R and the Aux buses.
OO
+6
AUX1
PRE
OO
+6
AUX2
PRE
OO
+6
AUX3
OO
+6
AUX4
POST
L R
BAL
=
PK !
PFL
STEREO
MUTE
7-8
POST
OO
30
5
10
20
5
0
10
Aux 1 & 2 sends
These control the level of the signals sent to the Aux 1 & 2
buses. The Aux 1 & 2 send controls are configured either as
two mono sends or as a stereo pair depending on the position
of the STEREO switch (please see above).
Auxes 1 & 2 are pre-fade, but muted when the Mute switch is
pressed. There is 6dB of gain at the fully clockwise position.
Aux 3 & 4 sends
These controls take a mono sum of the left & right stereo
channel signals from after the fader and send them to the Aux 3
and Aux 4 buses respectively. They are muted when the Mute
switch is pressed and have 6dB of gain at maximum.
PFL Switch & PK! LED
The Pre-Fade Listen switch takes a mono sum of the stereo
channel signals from before the fader and mute switch. When
pressed the signal will appear on the L R meters and be fed to
the headphones circuit for monitoring.
The PK! LED illuminates dimly to indicate the PFL switch is
pressed, and brightly to indicate the channel signal is within 5dB
of clipping.
13
13
Fader
The 100mm fader affects the level of the channel signal to the
left & right buses and Auxes 3 & 4. There is 10dB of gain at the
top and the unity gain position is marked by “0”.
14
14
To Next Page
Loading...
Need help?
General
