10 Rockwell Automation Publication 5094-IN001B-EN-P - May 2018
FLEX 5000 EtherNet/IP Adapters with RJ45 Ports
2. Strip insulation from the wires that you connect to the Power RTB.
For more information, refer to Specifications
on page 14.
3. Connect the 24V DC (-) wire from the external power supply to any - terminal.
4. Connect the 24V DC (+) wire from the external power supply to any + terminal.
Disconnect Wires from the Power RTB
If necessary, complete the following tasks to disconnect wires from the Power RTB on the adapter.
RTB Type Action
Screw 0.33…2.1 mm
2
(22…14 AWG) = Strip 12 ± 1 mm (0.47 ± 0.04 in.) of insulation from the wires.
Spring
0.33…1.3 mm
2
(22…16 AWG) = Strip 10 ± 1 mm (0.39 ± 0.04 in.) of insulation from the wires.
2.1 mm
2
(14 AWG) = Strip 15 ± 1 mm (0.59 ± 0.04 in.) of insulation from the wires.
RTB Type Action
Screw
1. Insert the wire into the terminal.
2. Turn the screwdriver to close the terminal on the wire. Torque the screw to 0.4 N•m (3.5 lb•in).
Spring
Push the wire into the terminal.
If the wire is too thin, crimp a wire ferrule on the wire and insert it.
RTB Type Action
Screw
1. Insert the wire into the terminal.
2. Turn the screwdriver to close the terminal on the wire. Torque the screw to 0.4 N•m (3.5 lb•in).
Spring
Push the wire into the terminal.
If the wire is too thin, crimp a wire ferrule on the wire and insert it.
WARNING: If you connect or disconnect wiring while power is applied, an electrical arc can occur. This could cause an explosion in hazardous location
installations. Be sure that power is removed or the area is nonhazardous before proceeding.
Screw-type RTB
Spring-type RTB
Screw-type RTB
Spring-type RTB
To Next Page
Loading...
Need help?
General
