Allen-Bradley FLEX I/O DeviceNet 1794-ADN User Manual

Rockwell Automation Publication 1794-IN099D-EN-P - November 2018 11
FLEX I/O DeviceNet Adapter Module
7. Complete the adapter mounting as shown below.
Push down and in at the same time to lock the adapter to the DIN rail.
If the adapter does not lock in place, use a screwdriver or similar device
to move the locking tab down while pressing the adapter flush onto the
DIN rail, and release the locking tab to lock the adapter module in place.
If necessary, push up on the locking tab to lock.
When the adapter is locked onto the DIN rail, gently push the Flexbus
connector into the adapter to complete the backplane.
8. Reinstall the module in the adjacent terminal base unit.
9. Reconnect adapter wiring as described in “Connecting Wiring.)
Connect Wiring
1. Connect the DeviceNet cable to the removable connector as shown.
C
44979
D
G
E
24V
COM
DeviceNet Connector
F
44980

Allen-Bradley FLEX I/O DeviceNet 1794-ADN Specifications

General

Brand	Allen-Bradley
Model	FLEX I/O DeviceNet 1794-ADN
Category	Control Unit
Language	English