Alto-Shaam 20 Series User Manual

MARINE ELECTRIC COMBITHERM — INSTALLATION MANUAL #7001-20.20ESM
PG
. 5
®
COMBITHERM
LOCATION SITE & INSTALLATION REQUIREMENTS
IMPROPER INSTALLATION, ADJUSTMENT,
ALTERATIONS, SERVICE, OR MAINTENANCE
C
AN CAUSE PROPERTY DAMAGE, INJURY 
OR DEATH.
READ THE INSTALLATION, OPERATING 
AND MAINTENANCE INSTRUCTIONS
THOROUGHLY BEFORE INSTALLING 
OR SERVICING THIS EQUIPMENT.
AVERTISSEMENT: UNE INSTALLATION, UN
ADJUSTEMENT, UNE ALTERATION, UN SERVICE
OU UN ENTRETIEN NON CONFORME AUX
NORMES PEUT CAUSER DES DOMMAGES A LA
PROPRIETE, DES BLESSURES OU LA MORT.
L
IRE ATTENTIVEMENT LES DIRECTIVES
D'OPERATION ET D'ENTRETIEN AVANT DE
FAIRE L'INSTALLATION, OU L'ENTRETIEN DE
CET EQUIPEMENT.
THE OVEN MUST REMAIN ON
THE PALLET WHILE BEING
MOVED TO THE INSTALLATION
SITE BY FORK LIFT OR
PALLET LIFT TRUCK.
N O T E : Note dimensions required for doorways
and aisles for access of the oven and
pallet to the installation site. Transport
the oven in an upright and level position
only. Do not tilt the oven.
®
I N S TA L L AT I O N C O D E S & S TA N D A R D S
The following codes and standards are required for installation of this oven:
AIR SUPPLY, ELECTRICAL CONNECTIONS, WATER CONNECTIONS, AND
WASTE WATER DISCHARGE.
N
O
T
E
Where automatically operated appliances are vented through a ventilating hood or exhaust
system equipped with a damper or with a power means of exhaust, provisions shall be made
to allow the equipment to operate only when the damper is open to a position to properly
vent the appliance and when the power means of exhaust is in operation.
IN ACCORDANCE WITH NFPA 54 COMMONWEALTH OF MASSACHUSETTS ONLY.

Alto-Shaam 20 Series Specifications

General

Brand	Alto-Shaam
Model	20 Series
Category	Oven
Language	English