NetWay8/NetWay16 - 7 -
Mounting Options:
Rack Mount Installation
1- Remove and discard factory installed screws from both sides of rack chassis (Fig. 7a).
2- Install mounting brackets (A) on the left and right side of rack chassis using the
four (4) flat head screws (B) (included) (Fig. 7b).
3- Place unit into desired EIA 19” rack position and secure with mounting screws (not included) (Fig. 7c).
Fig. 7
Fig. 7a Fig. 7b Fig. 7c
Top Top Top
Front
Front Left
Left Front Left
Remove
Wall Mount Installation
1- Install mounting brackets (A) on the left and right side of rack chassis using
four (4) flat head screws (B) (included) (Fig. 8a).
2- Place unit at desired location and secure with mounting screws
(not included) (Fig. 8b).
Caution: It is necessary to
make sure mounting screws
are securely fastened to a
beam when installing the
unit vertically.
Fig. 8
Shelf Installation
1- Position and affix rubber pads (C) (included) at each
corner on the bottom of the unit (Fig. 8).
2- Place unit in desired location.
B
A
C
Mounting Hardware (Included):
C
A
B
Left Side
Rubber Pad
Two (2) mounting brackets
Six (6) flat head screws
for mounting brackets.
Four (4) rubber pads.
B
A
Fig. 8
Fig. 8b
Fig. 8a
Dotted lines indicate studs
behind sheetrock.
To Next Page
Loading...
Need help?
General