3
Features
1
2
3
4
5
6
7
8
3
1 Door Handle
Ergonomically designed for one handed operation.
2 Unit Model and Serial Number
Located on the lower left hand side and back of the
oven.
3 Air Filters
''>8,'!0,"'8(#'&9!'(*/'+%&,/#;''?(.8'(/,'%!.(&,-'!"'
the lower sides of the oven. To remove, simply slide
out.
4 Display
Touch screen display provides user interface.
5 Control Dial
Provides easy menu navigation. Pushes in for
menu selection.
6 OFF Pad
Use to shut oven off.
7 Keypad
Use for time input, programmed pads and data
input.
8 EZCard Port
The oven is equipped with an EzCard Data Port.
Use with EZCard (available by request)
To program the oven using the EZCard:
Oven must be in Standby mode (Preheat must be OFF)
1. Open protective cover from bottom of keypad.
2. Insert the EZCard into the slot located below the keypad.
' @'>8,'?A (/-'.("'<,'*"#,/&,-'1!/9(/-#'!/'<(.B9(/-#;
3. From Standby, press and hold the “2” pad to go to “User Options”.
4. Go to Option #18 by pressing “Prev Option” on the screen or repeatedly pressing “Next Option”
5. Select the desired operation by highlighting “Transfer card to oven” or “Transfer oven to card” with the knob.
6. Press the “Start” pad to begin the transfer (The screen will indicate transferring and indicate done when transfer
is complete.)
7. Remove EZCard and close the protective cover.
To Next Page
Loading...
Need help?
General
