Lock Mechanism Handing Change Guide
Every assembly and installation is different (windloads, structural support, etc.), and Andersen strongly
recommends consultation with an Andersen supplier or an experienced contractor, architect, or structural engineer
prior to the assembly and installation of any Andersen product. Andersen has no responsibility in regard to the
post-manufactured assembly and installation of Andersen products.
Read all instructions carefully before attempting this procedure. If you have any questions about your ability
to complete this procedure, call Andersen at 1-888-888-7020 for further direction. Andersen WindowCare
®
service center hours are Monday through Friday, 7 a.m. to 7 p.m. Central Time and Saturday, 8 a.m. to 4 p.m.
Central Time. Thank you for choosing Andersen
®
products.
Windows and doors can be heavy.
Use safe lifting techniques and a
reasonable number of people with
enough strength to lift, carry and
install window and door products
to avoid injury and/or product
damage.
Use caution when working at elevated
heights and around unit openings. Follow
manufacturer’s instructions for safe use of
ladder and/or scaffolding. Failure to do so
may result in injury or death.
Follow manufacturer’s
instructions for safe operation
of hand/power tools. Always
wear safety glasses. Failure to
do so may result in injury and/
or product damage.
“Andersen” and all other marks where denoted are trademarks of Andersen Corporation. ©1996-2009 Andersen Corporation. All rights reserved.
Instruction Guide 0005204 BC Revised 03/19/09
Lock Mechanism Handing Change Guide
for Andersen
®
A-Series Hinged Inswing & Outswing; 400 Series
Frenchwood
®
Hinged Inswing & Outswing Patio Doors and
Tools & Supplies
• Safety Glasses
• 1/8" or Smaller Flat Blade Screwdriver
Component Identification
Lock Mechanism
400 Series Frenchwood
®
Hinged Inswing & Outswing Patio Doors
with Stormwatch
®
Protection
Lock handing can be changed without removing ▶
entire lock mechanism from panel.
1
To Next Page
Need help?
General
