Andersen E Series Replacement

3
9069265
8
Interior
9
Interior
7
Interior
11
Interior
10
Interior
Lift blind panel out of window sash. Lay on a clean at surface with the
interior surface face down. Position panel on table so that the control
knob is hanging over table edge. Failure to do so could result in panel
damage.
Disconnect the tilt control cable from the D-rod located along the top
side of the panel using .050" hex key.
Insert at blade screwdriver between blind panel frame and blind head
rail and pry. Repeat at locations of mounting clips as necessary to
release blind assembly.
Remove blind panel frame cord from blind panel frame.
Feed plastic tassels through the blind cord hole one at a time. Dispose
of blind properly.
Insert tilt control knob cable and cords from new blind through the holes
in blind panel frame.
12
Interior
The grommet is split to allow it to
be removed from the cords.
Control knob hanging over
edge of table
Tilt Control Cable
D-rod
.050" Hex Key
Flat Blade Screwdriver
Blind Panel Frame
Blind Head Rail
Blind Panel
Frame Grommet
Plastic Tassels
Blind Cord Hole
Blind Cords
Blind Panel Frame
Tilt Control Knob Cable

Andersen E Series Specifications

General

Brand	Andersen
Model	E Series
Category	Accessories
Language	English