39
7.2 Firmware Instruction
Auto update
Check the USB flash disk without “.bin” or “.BIN” file, copy the software from your computer to USB flash disk.
Method One:
1) Open TV and change to not USB signal source.
2) Insert USB flash disk into TV’s USB.
3˅TV detects the software, you can see a dialogue.
4˅Confirm, start to update.
5˅While finish updating, TV will restart itself.
6˅Take the USB flash disk out.
Method Two:
1˅ Insert the USB flash disk while TV without connecting power source.
2˅ Connecting AC, TV starts update, as you can see the TV’s LED flicker.
3˅ While finish updating, TV will restart itself.
4˅ Take the USB flash disk out.
Manual update
Check the USB flash disk without “.bin” or “.BIN” file, change the name of software to “MERGE.bin”
Copy “MERGE.bin” to USB flash disk
1) Insert USB flash disk, change TV to not USB signal source
2) Press “menu+456987+back”keys in the remote control, you can see a dialogue.
3) Confirm, start to update
4) While finish updating, TV will restart itself.
5) Take the USB flash disk out.
Press”menu+1999+back” keys in remote control into the factory menu to check the software version
Choose ”System Reset ”,press “OK” key
Restart TV by remote control
DDC Upgrade
The EDID has been contained in the software, so it is not necessary to update it alone.
To Next Page
Loading...
Need help?
General
