To Next Page

To Previous Page

Wall Mounting

Preparing to Install An Optional Wall Mounting Arm(Screw diameter is M4 and length is 10mm).

This monitor can be attached to a wall mounting arm you purchase separately. Disconnect power before this procedure.

Follow these steps:

1. Remove the base.

2. Follow the manufacturer’s instructions to assemble the wall mounting arm.

3. Place the wall mounting arm onto the back of the monitor. Line up the holes of the arm with the holes in the back of the

monitor.

4. Insert the 4 screws into the holes and tighten.

5. Reconnect the cables. Refer to the user’s manual that came with the optional wall mounting arm for instructions on

attaching it to the wall.

Note:

VESA mounting screw holes are not available for all models, please check with the dealer or o󰀩cial

department of AOC.

-5°

0° 90°

* Display design may di󰀨er from those illustrated.

WARNING:

1. To avoid potential screen damage, such as panel peeling, ensure that the monitor does not tilt downward by more than

-5 degrees.

2. Do not press the screen while adjusting the angle of the monitor. Grasp only the bezel.

Questions and Answers:

Need help?

Do you have a question about the AOC U34E2M and is the answer not in the manual?

AOC U34E2M Specifications

General

Weight and Dimensions