Aqua Computer ULTITUBE D5 PRO User Manual

ULTITUBE D5
In case the reservoir is installed without using the mounting plate of the pump, the
mounting plate and silicone damper of the pump can be replaced with a flat sili-
cone insert.
Please note that all mounting options that make use of the silicone damper require
the pump to be installed vertically above the damper and additionally the reservoir
to be firmly secured to the PC case! The silicone damper of the pump is not de-
signed to withstand lateral stress or transportation of the PC!
4.2.
4.2.4.2.
4.2. Electrical connections
Electrical connectionsElectrical connections
Electrical connections
ATTENTION: Completely turn off your power supply or disconnect the mains pow-
er cord from the wall outlet before connecting or disconnecting any cables to/from
the device!
4.3.
4.3.4.3.
4.3. Power Connector
Power ConnectorPower Connector
Power Connector
Connect a SATA power plug of your PC's power supply unit to this connector. Do
not use excessive force but double check the polarity of the plug if you are having
trouble to connect.
Pin assignment: Pin 1, 2, 3, 11: not connected
Pin 4, 5, 6, 10, 12: GND
Pin 7, 8, 9: 5 V DC
Pin 13, 14, 15: 12 V DC
4.4.
4.4.4.4.
4.4. Connector “USB”
Connector “USB”Connector “USB”
Connector “USB”
This connector is used for USB communication with a PC. Connect to an internal
USB header of your motherboard. Take special care to make sure the pin align-
ment matches your motherboard! The USB interface is used for data exchange
with the PC and not required for pump operation.
Pin assignment: Pin 1: GND (black, optional)
Pin 2: GND (black)
Pin 3: D+ (green)
Pin 4: D- (white)
Pin 5: +5 V(red)
4.5.
4.5.4.5.
4.5. Connector “Fan” for fan or flow sensor
Connector “Fan” for fan or flow sensorConnector “Fan” for fan or flow sensor
Connector “Fan” for fan or flow sensor
Depending on configuration, this connector can either be used as a PWM regulat-
ed fan output with speed signal processing or to connect a flow sensor. Simultane-
ous use of both functions is not possible!
Pin assignment: Pin 1: GND
Pin 2: 12 V / max. 25 W
Pin 3: Speed signal
Pin 4: PWM signal
© 2020 Aqua Computer GmbH & Co. KG - 5 -
Gelliehäuser Str. 1, 37130 Gleichen
c
o
m
p
u
t
e
r
a
q
u
a

Aqua Computer ULTITUBE D5 PRO Specifications

General

Brand	Aqua Computer
Model	ULTITUBE D5 PRO
Category	Computer Hardware
Language	English