EasyManuals Logo
Home>Ariens>Lawn Mower>Apex 52

Ariens Apex 52 User Manual

Ariens Apex 52
50 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #26 background imageLoading...
Page #26 background image
EN - 22
4. Remove T-bracket from upper slots in
hold-down brackets. Retain for
reinstallation.
5. Remove battery.
Clean Battery
1. Clean terminals and battery cable ends
with a wire brush.
2. Coat terminals with dielectric grease or
petroleum jelly.
Install Battery
Install Factory Battery
1. Reinstall positive cable and then the
negative cable.
2. Insert T bracket through lower slots in
hold-down brackets.
3. Tighten hex nut securing right hold-down
bracket to frame.
4. Return seat to operating position
Install U1 Battery
1. Reinstall positive cable and then the
negative cable.
2. Insert T bracket through upper slots in
hold-down brackets.
See Figure 25.
3. Tighten hex nut securing right hold-down
bracket to frame.
4. Return seat to operating position.
Charge Battery
Check battery with a voltmeter. If battery is
less than 11 volts, charge battery.
NOTICE: DO NOT fast charge. Charging at a
higher rate damages or destroys the battery.
ONLY use an automatic charger designed for
use with your battery.
NOTICE: Always follow information provided
on battery by battery manufacturer. Contact
battery manufacturer for detailed information
about charging.
1. Remove battery from unit. See Remove
Battery on page 21.
2. Place battery on bench or other well-
ventilated area.
3. Connect positive lead of charger to
positive battery terminal.
4. Connect negative lead of charger to
negative battery terminal.
5. Charge battery following battery
manufacturer’s instructions.
6. Reinstall battery. See Install Battery on
page 22.
Jump Starting
Ariens does not recommend jump starting
your unit. Jump-starting can damage engine
and system components. Refer to engine
manual for details.
CHECK MOWER BELTS
Check belts for wear and replace as needed.
CHECK HYDRAULIC SYSTEM
Check Hydraulic Oil Level
1. Place unit in service position. See
Service Position on page 17.
2. Check oil level in expansion tanks. Oil
should reach the cold fill indicator mark.
See Figure 26.
IMPORTANT: Engine should be cold when
checking initial oil level.
CAUTION: DO NOT allow direct
metal contact across battery
posts.
Figure 25

Other manuals for Ariens Apex 52

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Ariens Apex 52 and is the answer not in the manual?

Ariens Apex 52 Specifications

General IconGeneral
BrandAriens
ModelApex 52
CategoryLawn Mower
LanguageEnglish

Related product manuals