Operation
WARNING Involuntary start
Involuntary start of the machine may cause injury.
► Keep your hands away from the start and stop
device until you are ready to start the machine.
► Learn how the machine is switched off in the event
of an emergency.
► Stop the machine immediately in all cases of
power supply interruption.
Start and stop
TEX 3
Start the machine by first squeezing the safety trigger
(A) and then squeezing the trigger, while firmly
holding the handle.
TEX 12PSTEX 05P, TEX 09PS,
TEX 10PS
Start the machine by squeezing the trigger while
firmly holding the handle.
TEX 3
Stop the machine by first releasing the trigger and
then releasing the safety trigger (A). The trigger and
the safety trigger (A) returns automatically to the stop
position.
TEX 12PSTEX 05P, TEX 09PS,
TEX 10PS
Stop the machine by releasing the trigger. The trigger
returns automatically to the stop position.
Operating
Starting a cut
♦
Stand in a stable position with your feet well away
from the inserted tool.
♦
Press the machine against the working surface
before you start.
♦
Start collaring at such a distance from the edge
that the machine is capable of breaking the
material without levering.
♦
Never try to break off too large pieces. Adjust the
breaking distance (A) so that the inserted tool does
not get stuck.
Breaking
♦
Let the machine do the work; do not press too
hard.
♦
Avoid working in extremely hard materials for
example granite and reinforcing iron (re-bar) which
would cause substantial vibrations.
♦
Any form of idling, operating without insertion tool
or operating with an uplifted machine must be
avoided.
♦
When the machine is lifted, the start and stop
device must not be activated.
♦
Check regularly that the machine is well lubricated.
17© 2010 Atlas Copco Construction Tools AB | No. 9800 0799 90 | 2010-01-01
Original instructions
Safety and operating instructionsTEX 3, 05P, 09PS, 10PS, 12PS
To Next Page
Loading...
Need help?
General
