System 9 Installation and Operation
3
1 2 3 4
CHANNEL
1 2 3 4
CHANNEL
Receiver Controls and Functions
Figure A — Front Panel Controls and Functions
1. ANTENNAS: Position the “signal” antenna (1a) and
“ground” antenna (1b) as shown to the right and above right. Fully
extend both antennas by pulling on the endcaps.
2. RF INDICATOR: Lights to show presence of transmitter signal.
3. CHANNEL SELECT BUTTON: Soft-touch button selects channel.
4. CHANNEL INDICATOR LIGHTS: Lights to show which channel is
selected. A channel indicator LED will light when power is applied
to the receiver.
5. AF PEAK INDICATOR: Only lights when audio distortion
is present at maximum modulation. Not affected by
position of Volume control.
Figure B — Rear Panel Controls and Functions
1. SQUELCH CONTROL: Adjusts level of noise-muting circuit
(preset at factory but can be adjusted as circumstances warrant).
2. VOLUME CONTROL: Adjusts the audio level at the
1
/
4
" and XLRM
output jacks. Does not affect AF Peak indicator.
3. UNBALANCED AUDIO OUTPUT JACK:
1
/
4
" TS (Tip-Sleeve) or “mono”
phone jack. Use a shielded cable to connect to an unbalanced
4. BALANCED AUDIO OUTPUT JACK: XLRM-type connector. A
standard 2-conductor shielded cable can be used to connect the
receiver output to a balanced microphone-level input on a mixer or
5. POWER INPUT JACK: Connect the DC plug from the
included AC adapter.
6. CORD HOOK: Loop the cord around the cord hook to keep
the DC plug from pulling out accidentally.
PEAK
RF
1 2 3 4
CHANNEL
MIN.
SQUELCH VOLUME UNBALANCED
BALANCED
DC 12V IN
500mA
MAX. MIN. MAX.
1a 1b
2 53 4
1 2 3 54 6
To Next Page
Loading...
Need help?
General
