To Next Page

To Previous Page

AUX DC Inverter Free Match 50HZ R32

129

2.3 Parameter Setting by YK-L

Enter the setting interface

① Make sure the remote controller is off

② Press the two white button at the down side simultaneously more than 10s to enter the

address setting mode.

Parameter Setting

③ Press the [

∧

] or [

∨

] button to change the parameter series number

④ Press the [IClean] or [ECO] button to change the parameter correspondence

⑤ Press the [MODE] button to send order (Sent signal to display panels or receivers), Then

can hearing buzzer once

Questions and Answers:

Need help?

Do you have a question about the AUX AMWM-H18/4R3F and is the answer not in the manual?

AUX AMWM-H18/4R3F Specifications

General