ASSEMBLY!
!
STEP 2!
Connect the supplied ISO or quadlock plug to the plug of the
car. Also connect the CANBUS (only supplied with a customfit
radio and not with a 2 din universal radio) You can connect the
CANBUS to the white plug of the supplied ISO quadlock plug!
!
STEP 3!
Connect the small 20 pin plug of the ISO or quadlock adapter
cable to the back of the radio.!
!
STEP 4!
Turn on the ignition of the car, so that there is power to the
radio, see if the radio turns on by itself, the first time it can take
10 seconds before you get an image. When the radio turns on,
check that the sound and physical buttons on the radio are
working. Then switch off the ignition and see if the radio
switches off automatically, this sometimes takes a few
seconds. !
!
If the radio does not switch off automatically, remove the key from the
ignition. If the radio still does not turn off automatically, here is the solution for
checking the last page of this manual.!
!
!
!
!
!
!
!
To Next Page
Loading...
Need help?
General
