Page 8
13006 rev 0005
Here is a typical input setup
System installation
There will most likely be a number of cables involved in the installation of your home
entertainment system. Pre-planning is essential in order to maximize system efficiency.
We recommend the following as a means of helping you reach that goal:
Make a diagram of your proposed system by laying out the relative location of
each component in the system. Then lay out the proposed cable runs between
them. Number each cable and record its length on the diagram for future
reference.
Cable runs are critical in that they must be kept away from sources of power
radiation (amplifiers, power cords, heaters, etc...). For the sake of safety, they
should also be kept out of traffic areas.
The process of optimizing the system will include the type of cable, the length of
the run, and the obstructions it must deal with along its run. Your dealer can
advise you on the products available and their relative merits. If building custom
length audio cables is not your strength, your dealer should be able to help you
with that as well.
When possible, use a separate AC power line for the amplifier, one that is not
shared by any other component in the system of any other house hold
component.
Tip: Take a piece of stout strin
(lon
er than the lon
est cable run) and mark it at each foot of len
th.
Then do a mock cable run usin
the strin
, dressin
it neatly alon
the way. Count the divisions to the
next full foot, and add one foot to allow for some movement of the components. This will provide you with
the ideal cable len
th.
To Next Page
Loading...
Need help?
General
