29
19. Positioning of the
ignition and flame
sensing electrode
Figure 16
010905_0200
To measure combustion performance and hygiene levels of combustion products, the forced draught
boiler models are equipped with two test points on the tapered coupling specifically designed for
this purpose.
One of the two test points is connected to the exhaust flue duct to allow measurements of the com-
bustion products hygienic standards and combustion efficiency.
The second test point is connected to the comburant air inlet duct to check possible combustion
products circulation in case of coaxial ducts.
The exhaust flue duct test point allows measurements of the following:
• combustion products temperature;
• concentration of oxygen (O
2
) or, alternatively, of carbon dioxyde (CO
2
);
• concentration of carbon monoxyde (CO).
The comburant air temperature must be measured at the test point connected to the air inlet duct.
20. Check of combustion
parameters
Figure 17
020429_0300
flue gas
combustion air
gasket
To facilitate measurement of the combustion efficiency and improve the cleanliness of the production
products, the flue-sweeper function can be activated by proceeding as described below:
1) press the (2-3) together until the pointer “ ” appears on the display alongside the symbol
(about 3 seconds but no more than 6 seconds). In these conditions, the boiler operates at the ma-
ximum heat output set for central heating.
2) press either of the buttons to exit the function
21. Activating the
flue-sweeper function
To Next Page
Loading...
Need help?
General