ROTARY MACHINE RM600
Thank you for showing your confidence in us by purchasing the BEHRINGER ROTARY
MACHINE RM600. This ultimate effects pedal delivers the whole history of 3-dimensional
rotary speaker effects—at the touch of a footswitch. Experience the classic and swirling
sounds of famous signature rotary speakers in one compact pedal.
1. CONTROLS
Top view
The FAST control adjusts the rotating speed of the drum and the horn when FAST
is activated via footswitch (see ). The range does not overlap with the SLOW
control.
The SLOW control adjusts the rotating speed of the drum and the horn when SLOW is
activated via footswitch (see ). The range does not overlap with the FAST control.
The DRIVE control adjusts the amount of tube-like overdrive. In minimum position
the tube stage will be bypassed
The BLEND control adjusts the balance between the horn and the drum speaker.
Turning it to the right will boost the volume of the horn and lower the volume of the
drum.
The RAMP switch controls the time it takes to go from fast to slow rotary speed
and vice versa. You can select between FAST, MED and SLOW ramp time.
The MODEL switch selects between 3 famous signature rotary speakers (145,
L16 and 122).
The two color ON/BATT LED illuminates when active. The modulation is in slow
mode when the LED lights more red than blue, and it is in fast mode when the LED
lights more blue than red. The change from blue to red is synchronized with the
actual modulation speed.
Press the footswitch to activate/deactivate the effect. Hold the pedal depressed
for 2 seconds in order to switch between fast and slow modulation modes.
Use the 1/4" TS IN A and IN B connectors to plug in the instrument cables. For mono
use plug in IN A only.
The two 1/4" TS OUT A and OUT B connectors send the signal to your amp. Use
both connectors if you want to achieve full stereo rotary effect. For mono use plug
in OUT A only.
Use the DC IN connection to plug in a 9 V power supply (not included).
The BATTERY COMPARTMENT is located underneath the pedal cover. To install or
replace the 9 V battery (not included), press the hinges with a ballpoint pen and remove
the pedal cover. Be careful not to scratch the unit.
The RM600 has no on/off switch. As soon as you insert a plug into one of the
IN connectors, the RM600 begins running. When not using the RM600, remove
the plugs from the IN connectors. This extends the life of the battery.
The SERIAL NUMBER is located on the underside.
To Next Page
Need help?
Impedance
Power
Weight and Dimensions
