35 / EN
Fully Automatic Coffee Machine / User Manual
Problem Cause Solution
The appliance does not work. The appliance is not connected
to the mains.
- Plug in and press the switch.
- Check the cable and the Plug
No or delayed response in sev-
eral trials of pressing on func-
tion key on the panel
- Appliance is under an electro-
magnetic interference
- Dirt over the panel
Unplug the appliance. Restart
after few minutes Clean the
panel with the cloth provided
The coffee is not hot enough. - The cups have not been pre-
heated.
- The brewing unit is too cold.
Rinse the appliance at least 3
times before making the cof-
fee.
The coffee cannot come out
from spout.
Empty system function maybe
used before.
Press the hot water button
until water can come out from
spout.
The first cup of coffee is poor
quality.
The first run of grinder does
not pour sufficient quantity
coffee power into the brew-
ing unit.
Throw the coffee away. The
other coffees will always be of
good quality.
Coffee has no cream. - Coffee bean is not fresh. Change or using appropriate
brand of coffee bean.
The touch buttons are not
sensitive
Not pressing the touch button
from the front direction of the
appliance
Press the lower bottom part of
the icon of the touch button
from the front direction of the
appliance.
The appliance takes too long
time to warm up.
Excessive scale has built up. Descale the appliance.
The water tank is removed /
the water level is very low in
the water tank but have no
alert.
The area near the water tank
connector is wet.
Wipe the water around the wa-
ter tank connector
Internal drip tray is filled with a
lot of water.
Coffee powder too fine which
block the water to come out.
Adjust the coffee fineness to
bigger dot during grinder op-
eration.
6
Troubleshootng
To Next Page
Loading...
Need help?
General
