19
Connecting external
equipment
Headphones (optional)
The headphones must have an impedance of
between 8 and 32 ohms and have a 3.5 mm
stereo jack plug.
Plug the headphone jack into the headphone
socket of the TV.
Connecting a video
recorder
Plug one end of the SCART lead (not
supplied) into the back of the video recorder
and the other end into one of the SCART
sockets on the back of the TV.
Switch on the video recorder and the TV.
Press the AV button on the remote
control to select AV1, AV2 or AV3
(optional) to
correspond with
SCART socket you
are using on the
back of the TV.
Via SCART
Make sure the TV and video recorder are
both switched off.
Make sure the TV and video recorder are
both switched off.
Plug one end of the RCA lead into the video
and audio out sockets on the back of the
video recorder and plug the other end into
the video and audio in sockets of the TV.
If the sound is in mono use the Audio Input
L. In the SOUND menu select MONO.
Press the AV button repetitively
and select the AV3 mode by two
scart models or select AV4 mode
by three scart models.
Via RCA lead (optional)
Please note:
You can connect a RGB external equipment
via Scart 1. It is necessary to you use full
Scart cable for this purpose.
Select the video outputs of external device
by using its menu to RGB if it’s available.
AV
AV
To Next Page
Loading...
Need help?
General
