5. Wipe the exterior with a damp cloth to remove supercial stains. For stubborn stains, use
a nylon or plastic pad with a nonabrasive cleanser. Do not use metal scouring pads or
abrasive cleansers.
6. Dry and replace disassembled parts. Turn the removable lter holder so that the notch on
the front of the lter holder faces the front of the Coffee Maker – the lter holder handle
ts comfortably down into recessed areas on each side of the lter housing.
Add the cleaned permanent coffee lter basket.
7. Close the lid.
dESCALiNg
Special cleaning of your Coffee Maker is recommended at least once a month, depending on
frequency of use and quality of water used in the unit. If water in your area is especially hard,
the following cleaning procedure should be performed every 2 weeks, since minerals in water
can detract from the avor of the coffee and possibly lengthen brew time.
1. Fill carafe with 1 part white vinegar to three parts cold water. Pour water and vinegar
solution in to the water reservoir.
2. During cleaning, more steam will occur than during normal brewing.
3. BREW THE VINEGAR SOLUTION UNTIL CARAFE IS HALF FULL. Press the ON/AUTO/
OFF button to turn Coffee Maker OFF. When liquid stops dripping from the removable
lter holder into the carafe, remove the carafe and allow liquid to cool for 10 minutes.
When cooled, lift Coffee Maker lid and pour liquid back into the water reservoir.
4. Close the lid. Return carafe to the warming plate.
5. BREW THE VINEGAR SOLUTION again, allowing all the cleaning solution to empty into
the carafe. After dripping has stopped, empty contents of the carafe.
6. Allow Coffee Maker to cool for 10 minutes, rinse by brewing a carafe full of cold water.
Insert the permanent coffee lter basket into the removable lter holder before brewing.
7. At end of brew cycle, press the ON/AUTO/OFF button. Empty water in the carafe.
Remove used lter and wash carafe and removable lter holder in hot sudsy water.
Dry parts thoroughly.
8. When Coffee Maker has cooled, wipe exterior with a dry cloth.
STOriNg iNSTruCTiONS
1. Unplug unit and allow to cool.
2. Feed the cord into the cord storage area located at the back of the unit.
3. Store in its box or in a cool, dry place.
4. Never store unit while it is still plugged in.
9
To Next Page
Loading...
Need help?
General
