8
1. After approximately 2 cups of coffee have been brewed, the carafe may be slowly
removed and the coffee will stop dripping.
2. The flow valve is located on the bottom of the filter holder and is activated when
the carafe is removed. (See Figure 1.) This design makes it possible for you to
remove the carafe and pour a cup of coffee before the entire carafe is brewed.
IMPORTANT: When replacing the filter holder, the flow valve must be properly
inserted into the front hole of the machine, so that it can be seen as it sits on
the top of the carafe lid. (See Figure 1.)
3. When using this feature, make sure that the carafe is replaced under the filter holder
within 30 seconds to prevent overflow.
Gourmet strength coffee
The gourmet setting adjusts the brewing cycle of a full pot of coffee to extract a higher
percent of solubles. This results in a more avorful pot of coffee.
Bold strength coffee
The Bold setting adjusts the brewing cycle of a full pot of coffee, allowing more time
for the coffee to “steep” to extract further oils and avor from the coffee bean.
This results in a bolder tasting pot of coffee
1-4 cup brew cycle
Automatically adjusts the brewing process for maximum avor when brewing small
quantities. Ideal for brewing 1 to 4 cups of coffee.
* If 12 cups of water are poured into the water tank then 12 cups of coffee will brew.
Auto shut off
2 hours after the brewing cycle has stopped the unit will automatically turn the heating
element off.
BrEWING A SECOND CArAFE OF COFFEE
1. To brew another carafe of coffee, press the START button to turn the Coffee Maker
OFF. Remove plug from wall outlet. It is recommended that the Coffee Maker be
OFF and allowed to cool for 15 minutes between cycles.
CAUTION: Failure to allow Coffee Maker to cool sufficiently could cause hot steam
and spray when the water is added to the water reservoir. The hot steam can cause
severe burns.
2. Lift the Coffee Maker lid. Unfold the handle, lift and remove the permanent coffee
filter; discard used coffee grounds, rinse.
3. Lift the removable filter holder up and out of the Coffee Maker.
4. Rinse the glass carafe and removable filter holder in cool, clean water.
IMPORTANT: Before brewing a second carafe, always check to make sure
water level is past the MIN line; add the desired amount of cold tap water into
the water reservoir.
5. Place empty carafe on the warming plate.
6. Place the permanent filter in the removable filter holder. Measure 2 level
tablespoons of drip or regular grind coffee for each cup of coffee desired.
7. Place the filter holder down into the housing. Close the lid.
8. Plug Coffee Maker into a 120V AC electrical wall outlet.
9. Press the START button. Brewing will begin.
SO-310045_Bella Dots 12cup prog ES IM Interior r2.indd 8 2013-08-20 6:18 PM
To Next Page
Loading...
Need help?
General
