5
To Use the Wafe Maker
1. Plug the cord into your 120V AC wall outlet. The Red Power Light will
turn on indicating the appliance is operating.
NOTE: The Red Power Light will remain on until the appliance is
unplugged.
2. The Green Ready Light will turn on when the appliance reaches proper
cooking temperature. This should take approximately 3 to 5 minutes.
Once heated, ready times will be faster.
3. When the Green Ready Light turns on, open the Wafe Maker, and apply
a light layer of vegetable oil or melted shortening to the heating plates.
Spread the wafe batter evenly onto the lower heating plate.
4. Close the Wafe Maker and rotate the handle 180º clockwise (right)
until it locks for cooking.
5. After approximately 3 minutes, rotate the handle 180º counter-clockwise
(left) to unlock and then carefully open the Wafe Maker.
6. If the wafes are not dark enough, close the Wafe Maker, rotate to lock,
and then wait another 30 seconds. Repeat as needed.
7. When you are satised with your wafes, use a non-metallic utensil
to remove them from the heating plates.
8. To make more wafes, close the Wafe Maker until the Green Ready
Light comes on, then repeat from step 4.
9. When you are nished, unplug the Wafe Maker from the wall outlet.
After it has sufciently cooled, the heating plates may be wiped clean.
Locking and Unlocking Your Wafe Maker
Your Wafe Maker is unlocked only when the side with two indicator lights is
facing up. You can only open the Wafe Maker in the unlocked position.
Cleaning and Maintenance
WARNING: This appliance requires little maintenance. It contains no user
serviceable parts. Do not try to repair it yourself. Contact a qualied appliance
repair technician if the product requires servicing.
1. Always unplug the appliance, and allow it to cool down before cleaning.
2. You can easily remove any excess oils or crumbs without disassembling
the appliance.
3. Never submerge the appliance in water or place it in the dishwasher.
4. Use only plastic or wooden utensils on the heating plates. Metal may
damage the plates.
5. Use a soft cloth on the heating plates and occasionally a metal polish
intended for stainless steel on the outer housing. Never use abrasive
scouring pads or steel wool.
6. Do not use the Wafe Maker for anything other than making wafes.
Note: keep illustration
callouts aligned
SO-310695_Bella WM Rotating Waffle_Textured_IM.indd 5 2013-06-21 4:05 PM