Electronic Connections
Step 1: Use your fingers to remove the
3/8 inch nuts securing the bottom
electronics guard plate underneath the
back side of the gate. Remove the guard
plate itself to reveal the electronics core.
Note: If you are using 230v instead of the standard
115v, you will have to change the voltage settings.
Please see the Voltage Settings page at the end of this
manual for further details on how to change this.
Step 2: Connect the parallel
cord to both the back of the
machine's electrical core and the
operator panel box. Make sure
to secure them both by
tightening the set screws on
each end of the cord.
Step 3: Connect the 5v power
source to the back of the
operator panel box and
connect the other side to a wall
outlet.
To Next Page
Need help?
General
