Step 4: Connect an Ethernet cable from
your operator panel box to your
computer.
Step 5: Return the electronics
guard plate and use the ratchet
with the 3/8 inch socket to
secure the four 3/8 inch nuts.
Step 6: Connect the machine
power cord to the machine
underneath the electronics guard
plate and connect the other side
to a wall outlet.
Step 7: Attach the alligator clamp from
your torch power source to the ground
wire underneath the machine's electronics
core.
Step 8: Attach the torch trigger
connection from the machine's
electronics core (with the red and black
wires) to the back of your torch power
source.
To Next Page
Loading...
Need help?
General
