Bennett Read Tough 15 User Manual

5
Operations
Only operate your Bennett Read Tough 15 in accordance with the instruction
manual. Failure to follow these instructions will result in decreased cleaning
performance and may invalidate your guarantee.
Dry vacuuming:
Your Bennett Read Tough 15 Vacuum is perfect for vacuuming carpets, tiles,
mattresses, upholstery, curtains and car upholstery.
Setting up your Bennett Read Tough 15 for dry vacuuming:
1. Remove the motor unit (3) from the dirt tank (6) by lifting the locking clips (9)
upward
2. Ensure that the micro-particle filter (5) is securely installed in place
3. Replace motor unit (3) and clip locks in place (9)
4. Insert small end (opposite end to handle) of the flexi hose (12) into vacuum
function hose port (8)
5. Attach the 3 piece extension wand (14) to free end of flexi hose handle
6. Attach choice of cleaning head (15), (17) to free end of extension wand
7. Plug power cable into wall socket
8. Switch on unit using the power switch (1)
9. Vacuum in different directions across your surfaces to give you best results
After each cleaning session it is advisable that:
• The dirt tank be emptied and thoroughly rinsed and dried before storing
• The micro-particle filter is checked and cleaned if needed
This will ensure that the unit continues to deliver outstanding performance time & again
Wet Vacuuming:
Your Bennett Read Tough 15 can also suck up liquids* in and around your home…
Please note that the Bennett Read Tough 15 is NOT a carpet deep cleaner. Carpet
deep cleaning should be done with specialised deep cleaners.
Setting up your Bennett Read Tough 15 for wet vacuuming:
1. Remove the motor unit (3) from the water tank (6) by lifting the locking clips (9)
upward
2. Remove the micro-particle filter (5) (as explained below in the Maintenance and
Care section on the following page)
3. Replace motor unit (3) and clip locks in place (9)
4. Insert the large end of the flexi hose (12) into vacuum function hose port (8)
5. Attach 3 piece extension wand (14) to free end of the flexi hose
6. Attach wet pick-up vacuum nozzle (16) to free end of extension wand
7. Plug power cable into wall socket
8. Switch on unit using the power switch (1)
9. Vacuum wet spill / liquid from surface
10. When you are done, follow the cleaning instructions as outlined above
* Do not use to pick up boiling hot, flammable or combustible liquids
* Your Bennett Read Tough 15 is equipped with a float valve located at the bottom
of the motor unit which will partially shut off the suction as soon as the tank reaches
capacity. Immediately switch off the machine and empty the tank before continuing.

Bennett Read Tough 15 Specifications

General

Type	Wet & Dry Vacuum Cleaner
Model	Tough 15
Filter Type	HEPA filter
Capacity	15 liters
Dust Capacity	15 liters
Cord Length	5 meters