8
MAINTENANCE AND CARE
EMPTYING THE DIRT TANK:
1. Disconnect the Flexi-Hose (10) from the Motor Unit (2) by grasping the end of the hose
nearest the Hose Port (5), turning it anticlockwise and then pulling the hose outward
2. Take the unit to a disposal area
3. Lift the locking clips (3) to unlock the Dirt/Water Tank
4. Lift the Motor Unit (2) from the Dirt/Water Tank and place it carefully on ground
5. Lift the Dirt/Water Tank and empty contents into the disposal area
6. Rinse the Dirt/Water Tank under running water and dry it completely
CLEANING THE FILTER:
IMPORTANT: TO ENSURE OPTIMUM PERFORMANCE AND TO PREVENT DAMAGE TO
THE MOTOR, THE MICROPARTICLE FILTER MUST BE INSPECTED AND CLEANED WEEKLY
4. Wash the Microparticle Filter in warm water with a mild detergent
5. Allow the Microparticle Filter to air dry COMPLETELY before reinstalling it into the machine
Replacement Microparticle Filters are available from major retail outlets or at www.tevo.co.za
WARNING: NEVER OPERATE YOUR TOUGH 18 WITH A WET OR DAMP FILTER.
5. Attach the 2-Piece Extension Wand (12) to the Flexi-Hose Handle (11) (optional)
6. Plug the Power Cord (8) into a wall socket
7. Switch your Tough 18 on using the Power Switch (1)
8. Blow away leaves, sawdust or any light debris by aiming the Flexi-Hose Handle or Extension
Wand
3. Remove the Microparticle Filter as shown
below:
2. Loosen the Microparticle Filter (16) by
turning the Locking Nut anticlockwise:
1. Remove the Motor Unit (2) from the Dirt/Water Tank (4) as shown below:
To Next Page
Loading...
Need help?
General
