-10-
www.Berner.com/intelliswitch
NOTE – to navigate, use to select setting
use to change setting,
then press to enter the setting.
Stop: Immediately stops the air curtain and changes mode to OFF
"i": info button provides controller status and diagnostic data
Mode/Fan Speed:
Mode: Select your mode of operation (see next page)
Fan Speed: Sets the fan speed
Delay Time: Sets the amount of time the air curtain runs after the door closes
Temp Set: Sets the temperature the air curtain will maintain (heated units only)
Start Time: Programs the time of day the air curtain becomes active
Stop Time: Programs the time of day the air curtain stops running
Set Time/Day: Sets the clock time and day (used by programming)
Locked: Unit will run as programmed but settings cannot be changed
QUICK START INSTRUCTIONS
For your Berner Air Curtain with Intelliswitch™ Gen4
IMPORTANT NOTE!
If your air curtain unit is in “Locked” mode when you receive it:
Press and hold the for 5 seconds to unlock.
www.berner.com Berner International 800.245.4455
111 Progress Ave. / New Castle / PA / 16101 / USA
+
+
To Next Page
Loading...
Need help?
General
