8
Selected Location
WARNING: The selected location has to be able to support of supporting the expected load.
WARNING: An adequate drainage system has to be provided to deal with overflow water for both indoor and outdoor installations.
IMPORTANT: Because of the combined weight of the Lay-Z-Spa, water, and users, it is extremely important that the base where the
Lay-Z-Spa is installed is smooth, flat, level and capable of uniformly supporting the weight for the entire time the Lay-Z-Spa is installed
(not on the carpet or other similar material). If the Lay-Z-Spa is placed on a surface, which does not meet these requirements, any
damage caused by improper support is not covered under the manufacturer’s warranty. It is the responsibility of the Lay-Z-Spa owner to
assure the integrity of the site at all times.
1. Indoor Installation:
Be aware of special requirements if you install the spa indoors.
• Humidity is a natural side effect with Lay-Z-Spa installation. Determine the effects of airborne moisture on exposed wood, paper, etc.
in the proposed location. To minimize these effects it is best to provide plenty of ventilation to the selected area. An architect can help
determine if more ventilation is needed.
2. Outdoor Installation:
• During filling, draining or when in use, water may flow out of the spa. Therefore the Lay-Z-Spa should be installed near a floor drain.
• Do not leave the spa's surface exposed to direct sunlight for long periods of time.
INSTALLATION
NOTE: When inflating, you will notice that air will be expelled from the area where the
air hose connects to the pump, this is normal for technique requirements.
NOTE: Do not use an air compressor to inflate the pool.
NOTE:
Do not drag the pool on rough ground as this may cause damage to the pool liner.
NOTE: Inflation time for reference only.
NOTE: Pressure gauge is for inflation purpose only, and the value of the pressure
gauge is just for reference, should not be used as a precision instrument.
NOTE: Drawings for illustration purpose only. May not reflect
actual product. Not to scale.
1. Insert the plug.
2. Press the “RESET” button, the indicator light turns on.
3. Press the “TEST” button, the indicator light turns off.
4. Press the “RESET” button, the indicator light turns on.
5.
Press the “On/Off” button for 2 seconds, your pump is ready to use.
WARNING: The PRCD plug must be tested before each use to avoid risk of electric shock.
WARNING: Before inserting plug into a power outlet, make sure the current rate of the power outlet is suitable for the pump.
WARNING: Do not use the pump if this test fails and contact our Aftersales Service.
PRCD Test
RESET
TEST
2
RESET
TEST
4
RESET
TEST
1
3
RESET
TEST
Air Valve Check (for spa with quick inflation/deflation valve)
Always check the air valve carefully before inflation to ensure there is not an
air leak. If the air valve is loose,
use the provided wrench to fasten the air
valve following these steps:
With one hand, hold the backside of the air valve from the inner side of the spa
wall and turn the wrench clockwise.
NOTE:
1. Do not over tighten.
2. Do not adjust the air valve connector when the spa is in use.
S-S-004675/21x28.5cm/54112AU 54123AU 54129AU 54148AU 54154AU 54156AU 澳规SPA说明书/JS-YF-2016-B-05546/英
S-S-004675
To Next Page
Loading...
Need help?
General