1 2 3
P6609ASS16
It is important to follow these suggestions if you are setting up the spa during the winter
period. This will prevent damage to the PVC material and extend the life of your product
drastically.
•
If the ambient temperature is below 50°F(10°C), we suggest keeping the package
indoor where the temperature is above 59°F(15°C) for at least 2h before inflation. This
will make the spa liner more flexible and easier to set up.
•
Open the package in the same room where the temperature is above 59°F(15°C), and
inflate the spa using the spa heater.
•
Position the spa liner outdoor in the desired position, connect the spa heater and fill
with water.
Important: The water temperature used to fill the spa must be above 42.8°F(6°C),
otherwise when you begin to operate with the spa heater, the E03 alarm will appear.
Important: If the Freeze Shield™ system isn’t working, alarms will pop up on the spa.
Be sure to check the status of your spa if the outdoor temperature is below 42.8°F(6°C).
In case of a long-term absence from home when there is a risk of temperatures falling
below 42.8°F(6°C), we strongly suggest disassembling the spa and storing it following
the storage procedure. When you assemble the spa, the automatic warm function will
turn on. In this condition, the spa can be used when the temperature is lower than
42.8°F(6°C).
INSTALLATION
< 50°F(10°C)
> 59°F(15°C)
> 59°F(15°C)
SET-UP
INSTRUCTION
IN WINTER
14
To Next Page
Loading...
Need help?
General
