16 17
6. USAGE
6.1 Positioning the Shiatsu seat cover
1. Position the Shiatsu seat cover upright on a suitable seat with a seating surface and back rest (chair,
sofa or similar). Make sure that the entire surface of the seating surface
6
and the back area
5
are in
contact with the seat.
2. Ensure that the mains cable does not pose a trip hazard. Insert the mains plug
9
into a suitable socket.
6.2 Adjusting the neck section
Start by adjusting the neck section
1
of the Shiatsu seat cover as required. Both the height and the angle
can be adjusted. Always make sure that the 4D massage heads
2
are positioned so that they massage
your neck comfortably and are not directed at your head.
1. Adjusting the height: (The corresponding drawing
A
is shown on page 5.) Reach with one hand under
the centre of the neck section
1
. With the other hand, press the PRESS button
3
at the top of the rear
of the back section. This releases the locking mechanism and you can then move the neck section
1
to the desired height. Then release the PRESS button
3
and allow the neck section
1
to engage. The
neck section
1
is now fixed in place and you can remove your hands from the device.
2. Adjusting the tilt: (The corresponding drawing
B
is shown on page 5.) To adjust the tilt, hold one hand
on the neck section
1
and the other on the back section
4
to stabilise the seat cover. At the start of
the adjustment, move the neck section
1
backwards until you hear it engage. The neck section
1
is
now in line with the back section
5
. Now you can tilt the neck section
1
forwards until it has reached
the optimum position for you. The neck section
1
is now fixed backwards. To release it, move the neck
section
1
down once to a 90 degree position. The neck section
1
can now be moved freely. To read-
just, lift the neck section
1
up until it engages.
6.3 Starting use
CAUTION
Do not force or jam any part of your body, in particular your fingers, between the rotating massage heads
2
,
4
or their holders in the device.
At first, just press your back carefully against the Shiatsu seat cover. Then check carefully
whether the massage position is pleasant for you and then shift your weight gradually towards
the Shiatsu seat cover.
The massage should feel pleasant and relaxing at all times. If the massage is painful or uncom
-
fortable, stop the massage or change your position or the contact pressure.
1.
Selecting the seat position: Sit comfortably and upright on the Shiatsu seat cover. Take care to ensure
you are positioned in the middle of the massager and that the massage heads
4
can move to the left
and right of your spine.
2. Switching on the device: Switch on the Shiatsu seat cover with the ON/OFF button
18
. The massage
heads
4
in the back section
5
switch on automatically.
3.
Selecting the massage area for the back: Use the UPPER BACK button (upper back)
12
or the LOWER
BACK button (lower back)
13
to select the area you want to have massaged. The LED lights on the hand
switch
8
indicate the set massage area. The rotating massage heads
4
travel slowly upwards from
the starting position in the lowest area of the back and then move up and down in the set massage area
(upper or lower back).
4. “SPOT” massage: Press the SPOT button
14
to start usage in a specific spot in the back area. Use the
arrow buttons
15
to freely adjust the massage area up and down.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
