How To Use This Guide
This User’s Guide has been designed to help you get the
most satisfaction from your BISSELL Lift-Off. You’ll find
assembly and operating instructions,
safety precautions, as well as maintenance and
troubleshooting instructions. Please read this Guide thor-
oughly before assembling your vacuum cleaner.
Pay particular attention to the product diagram,
assembly instructions, and part names. Locate and
organize all parts before assembly. Familiarize
yourself with the parts and where they fit. Following
this User’s Guide will greatly enhance your ability to
get the most performance from your BISSELL Lift-Off
for many years.
The only tool you’ll need to assemble your vacuum
cleaner is a screwdriver.
Locate the vacuum Handle and remove the screw
packet taped to the base of the Handle.
Stand the vacuum upright and slide the base of
the Handle firmly into the grooves at the top of the
vacuum body.
Check to be sure the Handle is fitted to the vacuum
body. If there is a gap in front, continue to push firmly
until the Handle is flush.
Insert two of the screws from the screw packet into the
existing hole. Tighten securely with a screwdriver.
Position the Hose Assembly on the back of the canis
-
ter as shown.
Attach the Hose to the vacuum.
Standard Models - Use the remaining two screws from
the packet. Tighten securely with a screwdriver.
Twist ‘n Snap
™
Hose Models - (Select Models)
Position the Twist ‘n Snap Hose assembly on the vacuum
and line up the tabs on the base of the hose with the
corresponding notches. Turn the Twist ‘n Snap Hose to
the right to lock into place.
1.
Attach Handle To Vacuum
5
How To Put It Together
2.
3.
4.
Attach Vacuum Hose and Tools
1.
2.
WARNING:
Plastic film can be
dangerous. To avoid
danger of suffoca
-
tion, keep away from
babies and children.
Twist ‘n Snap Hose Models
Standard Models
To Next Page
Loading...
Need help?
General
