EasyManuals Logo
Home>Black & Decker>Pressure Washer>11BDE-210

Black & Decker 11BDE-210 User Manual

Black & Decker 11BDE-210
40 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #18 background imageLoading...
Page #18 background image
18- ENG
OPERATIONAL
ISSUE
POSSIBLE
CAUSE
SOLUTION
GFCI Plug
Malfunction
For GFCI reset procedure see Ground-fault
Circuit Interrupter Protection paragraph
under Power Supply & Electrical Info in
this manual. To order a replacement GFCI
or for GFCI installation instructions, please
contact our customer service department at
www.power-washer.us or by calling
1-800-381-0999.
Spray gun,
lance or high
pressure hose
leaking water
Improperly
connected
accessory
Verify all components (gun, lance, high
pressure hose) are properly connected
according to instructions provided in this
manual.
Leaking oil/
water from
pump
NOTE: A small amount of leakage is normal.
If oil/ water leakage from pump is excessive,
please locate the specific source of the leak
and contact our customer service department.
Contact our customer service department at
www.power-washer.us or 1-800-381-0999.
NOTE: Have the pressure washer present
when calling with this issue.
Low / surging
pressure or
motor does
not stop when
spray gun trigger
is released
NOTE: The
Pressure washer
is NOT receiving
a full volume of
incoming water
The machine
requires a
pressurized
water source
capable of
sustaining a
minimum of
20psi at 5 gpm.
Faucet is not
fully open
Verify incoming water supply faucet is open
at the maximum setting.
Garden hose
is too long or
it is kinked /
restricted
Use a maximum garden hose length of
50 ft. (15.2 m) (city water) or 25 ft. (7.5 m)
(well water). Ensure the garden hose is laid
out flat and does not have any kinks or
leaks. Unwrap garden hose from reel or
hook (if applicable). Replace garden hose if
necessary.
Water inlet
filter screen
is clogged
Remove the filter screen (O) from the water
inlet (M) and clean it thoroughly. Replace the
filter screen.
Extension cord
is too long or
wire gauge
is too small
We do not recommend the use of extension
cords with your pressure washer. If you
must use an extension cord, verify that it
meets the minimum requirements listed in the
Extension Cord paragraph under the Power
Supply & Electrical Info in this manual.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Black & Decker 11BDE-210 and is the answer not in the manual?

Black & Decker 11BDE-210 Specifications

General IconGeneral
BrandBlack & Decker
Model11BDE-210
CategoryPressure Washer
LanguageEnglish

Related product manuals