EasyManuals Logo
Home>Black & Decker>Saw>BDCCS18

Black & Decker BDCCS18 User Manual

Black & Decker BDCCS18
44 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #29 background imageLoading...
Page #29 background image
5
ENGLISH
(Original instructions)
Labels on tool
The following pictograms are shown on the tool:
:
Warning! Read all safety warnings and all
instructions. Failure to follow the warnings and
instructions listed below may result in electric
Additional safety instructions for batteries and
chargers
Batteries
u Never attempt to open for any reason.
u Do not expose the battery to water.
u Do not store in locations where the temperature may
exceed 40 °C.
u Charge only at ambient temperatures between 10 °C and
40 °C.
u Charge only using the charger provided with the tool.
u When disposing of batteries, follow the instructions given
in the section "Protecting the environment".
p
Do not attempt to charge damaged batteries.
Chargers
u Use your BLACK+DECKER charger only to charge the
battery in the tool with which it was supplied. Other
batteries could burst, causing personal injury and damage.
u Never attempt to charge non-rechargeable batteries.
u Have defective cords replaced immediately.
u Do not expose the charger to water.
u Do not open the charger.
u Do not probe the charger.
$
The charger is intended for indoor use only.
+
Read the instruction manual before use.
Electrical safety
#
Your charger is double insulated; therefore no
earth wire is required. Always check that the
mains voltage corresponds to the voltage on the
rating plate. Never attempt to replace the charger
unit with a regular mains plug.
u If the supply cord is damaged, it must be replaced by the
manufacturer or an authorised BLACK+DECKER Service
Centre in order to avoid a hazard.
Features
This tool includes some or all of the following features.
1. On / Off button
2. Lens
Fig. A
3. Battery (Not Supplied)
4. Charger (Not Supplied)
5. Charge indicator
Assembly
This product uses the battery and charger listed in
the chart below.
Description Catalogue Number
18V Lithium Ion Battery BL1118, BL1318, BL1518, BL2018
18V Lithium Ion Battery Charger 905902**, 905998**, 905713**
u
tool. Slide the battery into the receptacle and push until
the battery snaps into place.
u To remove the battery, push the release button (6) while at
the same time pulling the battery out of the receptacle.

Other manuals for Black & Decker BDCCS18

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Black & Decker BDCCS18 and is the answer not in the manual?

Black & Decker BDCCS18 Specifications

General IconGeneral
Blade bore1.2, 12.7 mm
Blade diameter140 mm
Idle speed (max)3700 RPM
Sound power level87 dB
Cutting depth (90º)43 mm
Sound pressure level76 dB
Diamond disc-
Vibration emission1.5 m/s²
Angle setting range0 - 45 °
Product colorBlack, Orange
Dust extraction portNo
Power sourceBattery
Battery voltage18 V
Battery capacity1.5 Ah
Saw blade includedYes
Number of batteries included1 pc(s)

Related product manuals