ENGLISH
(Original instructions)
6
Additional power tool safety warnings
@
Warning! Additional safety warnings for
hand-held saws
u Hold power tool by insulated gripping surfaces,
when performing an operation where the fastener
may contact hidden wiring. Fasteners contact-
ing a "live" wire may make exposed metal parts of
the power tool "live" and could give the operator an
electric shock.
u Use clamps or another practical way to secure
and support the workpiece to a stable platform.
Holding the work by hand or against your body leaves
it unstable and may lead to loss of control.
u Keep hands away from cutting area. ever reach
underneath the work piece any reason. Do not insert
blade and blade clamp. Do not stabilize the saw by
gripping the shoe.
u Keep blades sharp. Dull or damaged blades may
cause the saw to swerve or stall under pressure.
Always use the appropriate type of saw blade for the
workpiece material and type of cut.
u When cutting pipe or conduit, make sure that they
are free from water, electrical wiring, etc.
u Do not touch the workpiece or the blade immedi-
ately after operating the tool. They can become very
hot.
u Be aware of hidden hazards, before cutting into
wiring and pipes.
u The blade will continue to move after releasing the
switch. Always switch the tool off and wait for the saw
blade to come to a complete standstill before putting
the tool down.
Warning! The vibration emission value during actual
use of the power tool can differ from the declared value
depending on the ways in which the tool is used. The
vibration level may increase above the level stated.
u The intended use is described in this instruction
manual. The use of any accessory or attachment or
performance of any operation with this tool other than
those recommended in this instruction manual may
present a risk of personal injury and/or damage to
property.
Safety of others
u This appliance is not intended for use by persons
(including children) with reduced physical, sensory
or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision
or instruction concerning use of the appliance by a
person responsible for their safety.
u Children should be supervised to ensure that they do
not play with the appliance.
Residual risks.
Additional residual risks may arise when using the tool
which may not be included in the enclosed safety warn-
ings. These risks can arise from misuse, prolonged use
etc.
Even with the application of the relevant safety regulations
and the implementation of safety devices, certain residual
risks can not be avoided. These include:
u Injuries caused by touching any rotating/moving parts.
u Injuries caused when changing any parts, blades or
accessories.
u Injuries caused by prolonged use of a tool. When
using any tool for prolonged periods ensure you take
regular breaks.
u Impairment of hearing.
u Health hazards caused by breathing dust developed
when using your tool (example:- working with wood,
especially oak, beech and MDF.)
To Next Page
Loading...
Need help?
General
