12
See ʻTools-Electricʼ
– Yellow Pages –
for Service & Sales
Imported by
Black & Decker (U.S.) Inc.,
701 E. Joppa Rd.
Towson, MD 21286 U.S.A.
TROUBLESHOOTING
Problem Possible Cause Possible Solution
• Slow running, noisy or hot blades. • Dry, corroded blades. • Lubricate blades.
• Blades or blade support bent. • Straighten blade or blade support.
• Bent or damaged teeth. • Straighten teeth.
• Loose blade bolts. • Tighten blade bolts.
• Unit will not start. • Battery not installed properly. • Check battery installation.
• Battery not charged. • Check battery charging requirements.
• Lock off not fully operated. • Check that lock off is fully pulled back
prior to moving main trigger.
• Battery wonʼt charge. • Battery not inserted into charger. •Insert batteryinto charger until green LED appears.
Charge up to 8 hours if battery totally drained.
• Charger not plugged in. • Plug charger into a working outlet. Refer to
“Important Charging Notes” for more details.
• Check current at receptacle by plugging in a
lamp or other appliance.
• Check to see if receptacle is connected to a
light switch which turns power off when you turn
out the lights.
• Surrounding air temperature too hot • Move charger and tool to a surrounding air
or too cold. temperature of above 40 degree F (4.5°C) or
below 105 degree F (+40.5°C).
For assistance, visit our website www.blackanddecker.com for the location of the service center nearest you or call the BLACK &
DECKER help line at 1-800-544-6986.
To Previous Page
Loading...
Need help?
General
