HANDLE ASSEMBLY - (FIGURE B)
1. Align the round holes in the lower handle section (B1) with the two threaded studs (B2) in the side wall of the deck.
2. Push the handle section onto the studs fully.
3. Thread on two lock nuts (B3) and tighten with a 1/2 inch (13mm) wrench. Repeat for other side.
4. Slide the one piece upper handle into
one of the 3 adjustment positions (C1),
aligning the holes in the upper and
lower handles. NOTE: Adjust the han-
dle position at this time to suit your
height preference. Taller users may
want the handle assembled as
shown in figure C while shorter
users may want to adjust the upper
handle to one of the two remaining
height adjustment positions.
5. Insert the carriage bolt (C2) until the
head of the bolt is fully seated against
the handle.
6. Align the cord retainer (C3) with the
carriage bolt. Install the knob (C4),
tightening securely. The knobs should
always be on the outside of the handles
to avoid interference with the rear door
and grass bag. Insert carriage bolt and install knob for other side.
ASSEMBLING THE GRASS CATCHER (FIGURES D1, D2. D3, D4)
1. Before starting to assemble the grass bag to the frame, check that the grass bag and frame are similar to figure D1.
2. Slide the grass bag onto the frame as shown in figure D2 making sure bag is under frame handle.
3. Assemble the top clips to the frame as shown in figure D3, then assemble the two side clips and the bottom clip last.
4. Completely assembled grass catcher is shown in figure D4.
5
B
To Next Page
Loading...
Need help?
General
