WARNING: Some dust created by power sanding, sawing, grinding, drilling,
and other construction activities contains chemicals known to the State of
California to cause cancer, birth defects or other reproductive harm. Some
examples of these chemicals are:
Your risk from these exposures varies, depending on how often you do this type of
work. To reduce your exposure to these chemicals: work in a well ventilated area, and
work with approved safety equipment, such as those dust masks that are specially
designed to filter out microscopic particles.
Avoid prolonged contact with dust from power sanding, sawing, grinding, drilling,
and other construction activities. Wear protective clothing and wash exposed
areas with soap and water. Allowing dust to get into your mouth, eyes, or lay on the
skin may promote absorption of harmful chemicals.
WARNING: Use of this tool can generate and/or disperse dust, which may
cause serious and permanent respiratory or other injury. Always use NIOSH/OSHA
approved respiratory protection appropriate for the dust exposure. Direct particles
away from face and body.
The label on your tool may include the following symbols.
V ...........................volts A ......................... amperes
Hz ......................... hertz W ........................ watts
min .......................minutes
or AC .............alternating
current
or DC ...........direct current
n
o ....................... no load speed
..........................
Class II Construction
........................ earthing terminal
..........................safety alert symbol RPM or .../min ..revolutions or
reciprocations per minute
......................Read instruction manual before use
.......... ................Use proper respiratory protection
..........................Use proper eye protection
.......... ................Use proper hearing protection
SAFETY WARNINGS AND INSTRUCTIONS - BATTERIES
Do not disassemble or open, drop (mechanical abuse), crush, bend or deform, puncture, or shred.
Do not modify or remanufacture, attempt to insert foreign objects into the battery,
immerse or expose to water or other liquids, or expose to fire, excessive heat including
soldering irons, or put in microwave oven.
4
FUNCTIONAL DESCRIPTION
1) Trigger switch
2) Forward/Reverse/Lock off slider
3) Pivot release button
4) Bit holder
5) Light ring
6) Hex spindle
7) Charger port
8) Charger
9) Charger plug
A
1
8
7
5
4
3
2
6
9
To Next Page
Loading...
Need help?
General
