Cleaning
Warning! Blow dirt and dust out of the main
housing with dry air as often as dirt is seen
collecting in and around the air vents. Wear
approved eye protection and approved dust mask when
performing this procedure.
Warning! Never use solvents or other harsh
chemicals for cleaning the non-metallic parts of
the tool. These chemicals may weaken the
material of the parts. Use only mild soap and damp cloth to
clean the tool. Never let any liquid get inside the tool; never
immerse any part of the tool into liquid.
Technical data
8
ENGLISH
SPECIFICATION BPHM5
Voltage V 220-240
Frequency Hz 50/60
Power W 1010
Impact rate bpm 2900
Impact energy J 8.5
Chuck type SDS Max
Weight kg 6.3
To Next Page
Loading...
Need help?
General
