14
ENGLISH
Problem Possible causes Remedy
No detergent sucked in Adjustable nozzle on high pressure
setting
Set nozzle (E) on „
“ setting (fi g.3)
Detergent too dense Dilute with water
High pressure hose extension being
used
Fit original hose
Deposits or restriction in detergent
circuit
Flush with clean water and eliminate
any restrictions. If the problem per-
sists, contact an Authorised Service
Centre
Water escapes from thermo stat valve Water temperature inside pump
head has exceeded max. rated value
stated on nameplate
With appliance in operation, do not
stop the water jet for more than
5 minutes at a time
(*) If the motor stops and does not restart during operation, wait 2-3 minutes before repeating the start-up
procedure (Overload cutout has been tripped).
If the problem recurs more than once, contact your nearest Authorised Service Centre.
MODEL SERIAL NUMBER
Technical Data
Technical Data Unit PW 1600 SL
Flow rate l/min 5.16
Maximum fl ow rate l/min 6.67
Pressure MPa 8
Maximum pressure MPa 12
Power kW 1.6
Maximum inlet temperature °C 50
Maximum inlet pressure MPa 1
Gun repulsive force at
maximum pressure
N10.9
Pump oil type kg -
Protection class
-
II /
Motor insulation - Class F
Motor protection - IPX5
Voltage
V/Hz
220-240 /
50/60
Maximum permitted electrical
system impedance
Ω -
Sound pressure level
L
PA
(EN 60704-1)(K = 3 dB(A))
dB (A) 81.2
Sound power level
L
WA
(EN 60704-1)(K=3 dB(A))
dB (A) 89
Appliance vibration
(K = 1.5 m/s²):
m/s² 3.72
Weight kg 7.8
Subject to technical modifi cation!
To Next Page
Loading...
Need help?
General
