MAINTENANCE & STORAGE
The fridge must be defrosted regularly in order to ensure a correct operation. To
defrost the appliance, disconnect it, empty it and if necessary use a cloth with hot
water. Dry and clean the inside without using abrasive products. Never use a knife or
other sharp tool to remove ice. If the appliance is to remain unused for a longer period,
disconnect it, clean it and leave the fridge door slightly open during storage to prevent
unpleasant odours. Put some talcum powder in the gasket of the lid. If after such a
period the refrigerator does not cool when operating, switch it off again and leave it
turned upside down for few hours. Put it the right way up and connect again.
All repairs, if needed, particularly of the cooling unit or the gas burner system, can
only be carried out by a qualified technician.
If a problem occurs, first carry out the following checks:
• Are all accessories and sources of energy correct?
• Are the various connections correct?
• Is the appliance installed in a horizontal position? Is there sufficient ventilation?
• Is the mains supply correct in case of using 230V? Is the 12v battery sufficiently
charged?
• Is the gas cylinder sufficiently filled?
• Has the gas valve knob been pressed long enough?
• Has the thermostat knob been set to a higher and adequate position? . Have 2
modes of operation been selected by mistake at the same time? Is there too much
food inside the appliance?
• Is there sufficient circulation of cold air inside the appliance?
To Next Page
Loading...
Need help?
General